Table of Contents
Advertisement
In the Redundancy Settings screen, set the Port to use on the LED controller.
In the LED configuration example (English-92), the settings are as follows. After entering the value, click the
"Add" button.
Serial Number of Primary Sending Card : 1
Serial Number of Primary Port : 1
Serial Number of Backup Sending Card : 1
Serial Number of Backup Port : 4
Serial Number of Primary Sending Card : 1
Serial Number of Primary Port : 2
Serial Number of Backup Sending Card : 1
Serial Number of Backup Port : 5
Serial Number of Primary Sending Card : 1
Serial Number of Primary Port : 3
Serial Number of Backup Sending Card : 1
Serial Number of Backup Port : 6
When the settings configuration is complete, the Sending Card tab appears like below.
Click the "Send" button.
Click the "Save" button.
English - 95
Advertisement
Table of Contents
