Husqvarna PG 450 Operator's Manual page 13

2. Turn the ON/OFF switch to 1 to start the product. In
less than 5 seconds the product operates at the idle
speed.
To stop the product
CAUTION:
the surface when you stop the motor. The
tool plate rotates for a while after the motor
stops. Much off the dust can blow off in to
the air and the surface can be damaged.
CAUTION:
asphalt, paint or equivalent material, lift up
the front of the product slightly when the tool
plate stops. The product can attach to the
adhesive surface if not lifted.
1. Turn the ON/OFF switch to 0 to stop the motor.
2. Keep the tool plate against the surface. Make sure
that the tool plate does not rotate before you lift up
the front.
3. Pull out the power plug.
To replace the diamond tools
WARNING:
WARNING:
diamond tools can become very hot.
2209 - 002 - 21.03.2024
Do not lift the tool plate from
If you grind adhesive
Disconnect the power plug.
Use protective gloves, as
1. Turn the ON/OFF switch to 0 and disconnect the
power plug to stop the product.
2. Push the emergency stop.
3. Put the product into servicing position.
13