Safety - Husqvarna PG 450 Operator's Manual

Hide thumbs Also See for PG 450:
Table of Contents

Advertisement

Available languages

Available languages

Note:
Other symbols/decals on the product refer to
special certification requirements for some markets.
Product damage
We are not responsible for damages to our product if:
the product is incorrectly repaired.
Safety definitions
Warnings, cautions and notes are used to point out
specially important parts of the manual.
WARNING:
injury or death for the operator or bystanders
if the instructions in the manual are not
obeyed.
CAUTION:
damage to the product, other materials or
the adjacent area if the instructions in the
manual are not obeyed.
Note:
Used to give more information that is necessary
in a given situation.
General safety instructions
WARNING:
instructions that follow before you use the
product. Save all warnings and instructions.
Refer to the warnings and instructions for
future work, if it is necessary.
The safety section gives basic directions on how
to use the product correctly. This information is
not an alternative for professional knowledge and
experience. If you are in a situation where you do not
feel safe, stop and get professional support. Speak
to your dealer, service agent or an operator with
experience. Do not try a task where you do not feel
sure.
Keep work area clean and bright, this will decrease
the risk of accidents.
Safety instructions for operation
WARNING:
instructions that follow before you use the
product. Save all warnings and instructions
for future operations.
4
Used if there is a risk of
Used if there is a risk of
Read the warning
Read the warning
the product is repaired with parts that are not
from the manufacturer or not approved by the
manufacturer.
the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
the product is not repaired at an approved service
center or by an approved authority.

Safety

WARNING:
can cause circulatory damage or nerve
damage to persons with decreased blood
circulation. Get medical aid if you have
symptoms of overexposure to vibration.
These symptoms include numbness, loss
of feeling, tingling, pricking, pain, loss of
strength, changes in skin color or condition.
These symptoms usually show in the
fingers, hands or wrists.
Only use the product for operations that are given in
this manual. Refer to
Use personal protective equipment. Refer
Personal protective equipment on page 5 .
to
Do not go away from the product when the motor is
on.
Connect the motor cable to the electrical enclosure
before you connect the plug.
Do not let other operators use the product if they
have not read and understood the contents of this
operators manual.
Only start the product with the brush strip attached.
Brush strip must seal tightly to the surface,
especially during dry surface operations.
Make sure that the brush strip is not damaged and is
clean. Replace damaged brush strip.
Keep the motor on until the fan comes to a complete
stop.
Lift the grinding head if a check of the start
procedure is necessary.
Only start the product when the grinding head is put
on the surface.
Make sure that only approved persons are in the
work area.
Do not use the product in areas where fire or
explosions can occur.
Always disassemble the diamond tool after each
operation.
Make sure that the tool plate does not rotate if you
lift up the product. The tool plate continues to rotate
for a while after the motor stops.
When you remove diamond tools, let the product
become cool and use protective gloves. Diamond
tools are very hot after use.
Overexposure to vibration
Intended use on page 2 .
2209 - 002 - 21.03.2024

Advertisement

Table of Contents
loading

Table of Contents