DeWalt DW089 Instruction Manual page 32

Additional Safety Instructions for Lasers
• This laser complies with class 2 according to EN 60825-1:2007.
Do not replace a laser diode with a different type. If damaged,
have the laser repaired by an authorized repair agent.
• Do not use the laser for any purpose other than projecting laser
lines.
An exposure of the eye to the beam of a class 2 laser is considered
safe for a maximum of 0.25 seconds. Eyelid reflexes will normally
provide adequate protection. At distances over 1 m, the laser
complies with class 1 and thus is considered completely safe.
• Never look into the laser beam directly and intentionally.
• Do not use optical tools to view the laser beam.
• Do not set up the tool at a position where the laser beam can
cross any person at head height.
• Do not let children come in contact with the laser.
Important Safety Instructions for
Batteries
WARNING: Batteries can explode, or leak, and can cause
injury or fire. To reduce this risk:
• Carefully follow all instructions and warnings on the battery
label and package.
• Always insert batteries correctly with regard to polarity
(+ and –), marked on the battery and the equipment.
• Do not short battery terminals.
• Do not charge batteries.
• Do not mix old and new batteries. Replace all of them at the
same time with new batteries of the same brand and type.
• Remove dead batteries immediately and dispose of per local
codes.
• Do not dispose of batteries in fire.
• Keep batteries out of reach of children.
• Remove batteries if the device will not be used for several
months.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
Assembly and Adjustment
WARNING! Do not place the laser in a position which may
cause anyone to intentionally or unintentionally stare into the
laser beam. Serious eye injury may result from staring at the beam.
Unpacking
FITTING THE WARNING LABEL
The safety warnings on the label shown on the laser must be
formulated in the language of the user.
For that purpose, a separate sheet of self-adhesive labels has been
supplied with the tool.
WARNING: Check that the safety warnings on the label have been
formulated in your language.
The warnings should read as follows:
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
• If the warnings are in a foreign language, proceed as follows:
– Remove the required label from the sheet.
– Carefully place the label over the existing label.
– Press the label in place.
Batteries (fi g. 1)
BATTERY TYPE
This laser operates on four LR6 (AA-size) batteries.
32