Husqvarna LC 251i Operator's Manual page 10

2. Put the handle on top of the product. Tilt the handle
against the box for support of the handle. Refer to
the illustration.
3. Push the screw (A) through the handle (B), the
plastic washer (C) and the handle support bracket
(D).
C
B
A
4. Tighten the nut (E) fully.
5. Remove the product from the box.
10
D E
6. Fold the handle to upright position.
7. Set the handle height to the lowest position. Refer to
To adjust the handle on page 11 .
8. Attach the cable to the lower part of the handle with
the cable clip.
9. Attach the lower part of the cable to the handle
support bracket with the cable tie. Cut off the
remaining part of the cable tie.
Note:
Make sure that the cable is correctly
attached. A cable that is too loose cause damage
to the cable when the grass catcher is installed.
2207 - 003 - 26.10.2023