Husqvarna LC 251i Operator's Manual page 15

1. Lift the rear cover.
2. Put the grass catcher on the bracket.
3. Release the rear cover and put it on top of the grass
bag frame.
To change the product to side
discharge mode
1. Lift the rear cover and remove the grass bag, if it is
installed.
2. Close the rear cover and make sure that it is tightly
closed against the product.
3. Lift the discharge lock.
2207 - 003 - 26.10.2023
4. Open the side discharge cover and install the side
discharge deflector onto the support pins.
5. Let the side discharge cover close against the
side discharge deflector. Make sure that the side
discharge deflector is tightly in position before you
operate the product.
To empty the grass catcher
CAUTION:
you move it to prevent wear.
1. Lift the grass catcher with the frame handle.
2. Use the frame handle and the bag handle when you
empty the grass catcher.
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Use the highest cutting height when you start to cut
the grass. Examine the result and lower the cutting
height to an applicable level. If the grass is very long,
operate slowly and cut 2 times if it is necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
• Lift the rear cover and remove the grass catcher.
• If a mulch plug and a mulch blade are attached,
remove them.
• Close the rear cover before you operate the product.
When you operate the product, the cut grass
discharges below the rear cover.
Lift the grass catcher when
15