Table of Contents
Advertisement
8.2. 10°C Heat operation
10°C Heat operation maintains the room temperature at 10°C so as to
prevent the room temperature from dropping too low.
Press
to activate the 10°C Heat operation.
The indoor unit will emit 1 short beep and [
indoor unit will turn on.
Press
to turn off the air conditioner.
[
] indicator will turn off .
NOTES:
• During the 10°C Heat operation, only
• When the room temperature is warm enough, this operation will not
perform.
9. WLAN control
This operation manual describes only the setting procedure of the
remote controller.
For how to operate the mobile app, refer to the operation manual of the
mobile app.
NOTES:
• The air conditioner settings from the mobile app is not be refl ected
in the wireless remote controller.
• It is not possible to operate and monitor by the mobile app while the
power supply of the air conditioner is disconnected (via breaker or
plug).
• The room temperature is displayed in the mobile app during
operation. However, the displayed room temperature may not be
correct depending on the situation in the room or the air conditioner
operating status. Use this only as a reference.
• If the mobile app and remote controller settings diff er, the latest
operation performed takes priority.
• If timer settings are done from the mobile app and from the wireless
or wired remote controller, both timer settings become active.
The contents of wireless LAN label are necessary for wireless LAN
setup.
Write down the SSID and the PIN code to the following table.
Open the intake grille.
*The layout of the wireless LAN label may diff er by the part or model.
] indicator on the
is valid.
Wireless LAN label
QR Code
En-7
Information on WLAN device
SSID
PIN
Wireless LAN-compatible
IEEE 802.11 b/g/n
standard
2.4 GHz
Frequency bands
(in the U.S. or Canada: 1 ch to 11 ch)
(in the other regions: 1 ch to 13 ch)
Maximum radio-frequency
40 mW
power
Open
WEP
Wireless LAN security
WPA (PSK)
WPA2_Personal (PSK)
WPS for same-LAN Registration
"AIRSTAGE Mobile" is a trademark of FUJITSU GENERAL LIMITED.
Android and Google Play are registered trademarks of Google LLC.
App Store is a service mark of Apple Inc., registered in the U.S. and
other countries.
IOS is a trademark or registered trademark of Cisco in the U.S. and
other countries and is used under license.
"QR Code" is a registered trademark of DENSO WAVE
INCORPORATED.
9.1. Usage precautions
Usage precautions for wireless LAN control
WARNING
• Do not repair, disassemble or remodel the WLAN
device.
• Do not get the WLAN device wet or use it in locations
with lots of moisture.
• Do not operate with wet hands.
• Do not install the WLAN device in locations where
the use of wireless equipment is prohibited (e.g.,
hospitals).
• Do not use the WLAN control in a room where young
children or people with physical disability are present.
• Do not use the WLAN control near persons with a
pacemaker or similar devices.
• Do not use the WLAN control near automatic control
equipment (e.g., automatic doors and fi re alarms).
CAUTION
• When cleaning the air conditioner, be sure to stop the
operation and turn off the power. Otherwise, there is
a risk of electric shock or injury.
● When you use the WLAN control, it will become possible to
operate the air conditioner from locations where you cannot
see it directly. This means that people in the room may be
exposed to the unintended operation of the air conditioner.
Check the condition of the room before using the WLAN
control.
• Be sure to check in advance that there are no malfunctions
of the air conditioner.
• Make sure that the airfl ow from the air conditioner will not
cause any adverse eff ects.
Objects may fall down causing personal injury, fi re, or
damage to property.
Advertisement
Table of Contents
