Philips 4000 Series User Manual page 51

(4). Port: The port number for the FTP server is available in
the range from 1025 to 65535, the default setting is 2121.
The following port number cannot be used:
8000 / 9988 / 15220 / 28123 / 28124 and SICP network
port (default 5000).
Finally, manually reboot the system to apply the FTP settings.
Remote Control
Settings -> Signage Display -> Server Settings -> Remote
Control
Click the checkbox "Enable" to enable or disable the remote
control client service. The default setting is "Enabled". To use
the remote control feature, the device must be bound with
the remote control server.
In the entry field of "Server", input the URL address with
the prefix of "https://". If the device is not bound with the
remote control server, please enter the PIN code provided by
the server.
Bind status:
(1). If the device does not have an appropriate network
connection, a message "Network is disconnected" will
appear.
(2). If the device is equipped with a network function,
but is not connected to the remote control server, a
message "Server is disconnected" will appear.
(3). If a server is connected, but not bound, a message
"Server is unbinded" will appear.
(4). If the device is bound with the server successfully, a
message "Server is binded" will appear.
(5). If the PIN code is not correct, a message "Error PIN
code" will appear.
SNMP
Enable/Disable the SNMP service.
Please refer to the SNMP user manual.
ADB over Network
You can access ADB over a network connection with port
5555.
49
65BDL4650D/75BDL4650D/86BDL4650D