Figure 19. Installing the battery
Steps
1. Using the alignment posts, place the battery on the palm-rest assembly.
2. Align the screw holes on the battery with the screw holes on the system board and palm-rest assembly.
3. Replace the six screws (M2x4.5) that secure the battery to the system board and palm-rest assembly.
4. Connect the battery cable to the connector (BATT) on the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
After working inside your
computer.
Battery cable
Removing the battery cable
CAUTION:
The information in this removal section is intended for authorized service technicians only.
42
Removing and installing Field Replaceable Units (FRUs)