Figure 44. Installing the Type-C brackets
Steps
1. Align and the screw holes on the right Type-C bracket with the screw holes on the system board.
2. Replace the two screws (M2x4.5) that secure the right Type-C bracket to the system board.
3. Align and the screw holes on the left Type-C bracket with the screw holes on the palm rest and keyboard assembly and
system board.
4. Replace the three screws (M2x4.5) that secure the left Type-C bracket to the palm rest and keyboard assembly and system
board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
System board
Removing the system board
CAUTION:
The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
solid-state
5. Remove the fans.
After working inside your
Before working inside your
drive.
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
65