Location Of Controls - Toshiba KT-1950 Service Data

KT-1950
1. LOCATION OF CONTROLS
[DC IN 6V] jack
[Input Selector] switch (rear side)
Set this switch according to the type of input con-
nected to the [MIC/AUX IN] jack. Normally, it will
be left in the Built-in mic/External mic position.
[= 4STOP OPEN] button
Press this button to stop the tape during playback,
recording, fast forward winding or rewinding, and
press again to open the cassette compartment.
[ @ REC] button
Press this button together with the [€PLAY] button
to start recording.
[€<CUE FF] button
For fast forward winding of the tape to locate desired
tape section rapidly.
[>>REVIEW REW] button
For rapid rewinding of the tape and repeated play-
back.
Tape counter and Reset button
[REC/BATT] indicator lamp
This indicator lamp shows the condition of the
batteries during playback, and the recording level
during recording.
Built-in microphone
[MIC/AUX IN] jack
For recording from an external microphone or some
other external equipment (e.g. TV).
[REMOTE] jack
[EAR] jack
[ I} PAUSE] button
Figure 1
Note: 1. When the [#4 STOP/OPEN] button is pressed backwards before attempting to remove =
with the recorder standing upright on a level cassette tape.
surface, the cassette compartment cover will 2. Open the cassette compartment by hand wren
not open very easily. Incline the recorder there is no cassette tape inside.