Table of Contents
Advertisement
| KT-1950
2. DISASSEMBLY INSTRUCTIONS
(2)
After removing four screws
(A) (B) (C) (D), open
the back cabinet and remove a built-in microphone
from its cap. The back cabinet can be removed out.
= (A) Screw 1.46x 5mm
Removal of Front Cabinet
(1)
Remove the back cabinet.
(2)
Remove a screw (E) to take the front panel off.
To Open P.C. Board
(1)
Remove the back cabinet.
(2)
Remove a screw (F) to open the P.C. Board.
Note:
When the P.C. Board is fixed, make sure to insert
Req Coller
]
the REC spring into a hole on the record/playback
—
change-over switch.
© (D) Screw 26x 8mm
ei
4
P.C.B. Plate
oe
Figure 4
REC/PLAY Switch
REC Spring
wy
Playback Mode
Proceed according to the numbered steps.
4. To
stop
the tape,
press
the
[ # 4 STOP/OPEN]
3. Adjust the [VOLUME]
control.
button.
.
\\\
a
2. Press the [¢PLAY]
button.
Ash
1. Open the cassette compartment,
and insert a cassette
wo
tape.
Figure 5
Advertisement
Table of Contents
