Philips NeoPix 530 User Manual page 17

Problem
The projector does not react to remote
control commands.
The temperature of the projector's surface
is warm.
The projector does not work after I connect
it to a laptop.
Black / White Pixels
Troubleshooting
Solution
• Check the batteries of the remote control.
• For this projector it is normal to generate
moderate heat during operation.
• Check that the HDMI™ cable is plugged in
correctly.
• Make sure that the laptop has been switched to
projector display.
An LCD display may contain a small number of
pixels that do not function normally (also known
as "dead pixels" or "black pixels"). Your display
has been inspected and is in compliance with the
manufacturer's specifications, meaning that any
pixel defects do not affect the operation or use of
your display. Without prejudice to generality of the
foregoing, dead pixels or black pixels not exceeding
5 dots meet the factory specifications and are not
considered a defect under this warranty.
Concerning dust:
Dust may appear during the use of a projector.
Without prejudice to generality of the foregoing,
dust spots not exceeding 3 dots meet the factory
specifications and are not considered a defect
under this warranty. Please clean the lens with a
gentle specific glass tissue. You can also push dry air
into the product by the side holes in order to clean
the optical engine inside.
17