Advertisement
5
Remove the cassette from its package. Then remove the red paper strip from the end.
6
Position the cassette as shown below.
7
Carefully align the cassette and its ribbon with the slot, then gently push in the cassette until it clicks into place
beneath the latch.
Caution
You must align the cassette and its ribbon with the slot or
you will damage it when you slide it in.
8
Flip up the ink cover and push it closed.
9
Slide in the printer until it stops.
10
Push in on the printer lock as you turn it clockwise to tighten it.
If it doesn't tighten, push the printer in further and try again.
11
Flip up the lock cover.
Caution
Make sure to lock the printer securely and close the lock cover completely
or the printer won't print.
Loading Paper
1
Open the paper cassette lid.
2
Load up to 20 sheets of paper from the included paper package. Position the paper with the shiny side face up,
with the wide bordered edge facing the hinge of the cassette, and the narrow bordered end facing the open end
of the cassette.
Caution
Don't remove the perforated borders on the paper before you print.
The paper may jam or the printer may malfunction when it loads the paper.
Don't touch the shiny side of the paper or it will become discolored.
3
Close the cassette lid.
4
Slide the cassette all the way into its slot, open end first,
until it clicks into place.
5
Close the printer cover.
Inserting the Remote Control
Batteries
1
Press in on the top of the battery cover on the back of the remote
control. Then slide the cover down and off the remote.
2
Insert the batteries as shown here, making sure the + and – ends
face the right way. Then push them down flat.
3
Place the cover into the grooves and slide the cover all the way up
until it clicks into place.
Plastic point
should face up
Covered ends of the
ribbon should face out
Shiny side up
+
Wide border
Narrow border
+
Advertisement
