Advertisement
If AUTO CLOCK SET was incomplete, manually
set the clock as follows.
Press ACTION on the remote to display
SET CLOCK Menu screen
When moving unit to a new location, or if a mistake
was made in the Initial Setup section.
• Make sure a tape is not insetted in the unit.
Press _IL • to select the month and
press I_to set. In the same manner,
select and set the date, year, time, and
DST. (Daylight Saving Time)
Press ACTION twice to start CLOCK and
exit.
I
Turn the unit
II
Power on.
rji
Press and hold both
PLAY/REPEAT
and FF on the
unit for more than 5 seconds.
• The powerwill shut off.
• Please ignore"NO CASSETTE"
warning.
3
Do "Initial Setup"
on page
8.
SELECT/SET
•
:CH UP
' :CH DOWN
• :VOL UP
• :VOL DOWN
Note to CABLE System Installer
This reminder is provided to call the CABLE
(Cable TV) System Installers attention to
Article 820-40 of the NEC that provides
guidelines for proper grounding and, in
particular, specifies that the cable ground
shall be connected to the grounding system
of the building, as close to the point of cable
entry as practical.
Advertisement
