Detaching And Refitting The Rails; Removing And Installing The Steam Filter - Siemens HB76AU 60A Series Instruction Manual

Area Cleaning agents
Oven front Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Do not use glass cleaners or
glass scrapers.
Stainless steel Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Remove flecks of limescale,
grease, starch and albumin (e.g. egg
white) immediately. Corrosion can form
under such residues.
Special stainless steel cleaning products
suitable for warm surfaces are available
from our after-sales service or from
specialist retailers. Apply a thin layer of
the cleaning product with a soft cloth.
Door panels Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Door cover Stainless steel cleaning agents (available
from our after-sales service or from
specialist retailers):
Please observe the manufacturer's
instructions.
Cooking Hot soapy water or a vinegar solution:
compartment Clean with a dish cloth.
If there are heavy deposits of dirt, use a
stainless steel scouring pad or oven
cleaner. Only use when the cooking
compartment is cold.
It is best to use the self-cleaning function.
Observe the instructions in the Self-
cleaning section when doing so.
Glass cover for the Hot soapy water:
oven light Clean with a dish cloth.
Shelves Hot soapy water:
Soak and clean with a dish cloth or
brush.
Telescopic shelves Hot soapy water:
Clean with a dish cloth or a brush.
Do not soak. Clean in the dishwasher, or
in the oven as part of the self-cleaning
programme. The rails may be damaged
causing them to jam.
Accessories Hot soapy water:
Soak and clean with a dish cloth or
brush.
16

Detaching and refitting the rails

The rails can be removed for cleaning. The oven must have
cooled down.
Detaching the rails
Lift up the front of the rail
1.
and unhook it (figure A).
2.
Then pull the whole rail forward
3.
and remove it (Fig. B).
4.
$


Clean the rails with cleaning agent and a sponge. For stubborn
deposits of dirt, use a brush.
Refitting the rails
First insert the rail into the rear socket, press it to the back
1.
slightly (figure A),
and then hook it into the front socket (figure B)
2.
$
The rails fit both the left and right sides. The kinked section
must always be at the bottom.

Removing and installing the steam filter

A steam filter is located on the oven ceiling. This filters out
grease particles in the exhaust air and reduces odours. The
filter must occasionally be cleaned.
Removal
Using a 6 mm Allen key, turn the filter holder anti-clockwise
1.
and remove (figure A).
Remove both filter elements.
2.
$
You can use detergent to clean the filter holder and the thin
single-layer filter element or you can clean them in the
dishwasher cutlery basket. The thicker filter element should not
be cleaned. The coating may be damaged.
%


%