Advertisement
en-us_main.book.book Page 7 Friday, February 16, 2024 1:13 PM
-
J
Distance between cutout and the wall behind the cooktop
K
Width of unprotected overhead cabinets
L
Depth of unprotected overhead cabinets
M
Clearance from countertop to unprotected overhead surface
N
Clearance from countertop to nearest cabinet on either side of unit
Installing the Cooktop
Installing the Cooktop Unit
CAUTION
• Please read the following instructions, as well as
the Important Safety Instructions section at the
front of this manual, completely and carefully
BEFORE installing and/or operating the gas
cooktop. Improper installation, adjustment,
service, or maintenance can cause personal
injury or property damage.
NOTE
• To ensure proper installation, we strongly
recommend that you hire a professional
installer.
Sponge
• Remove the pan supports, the burner lid and
flame spreader and carefully turn the appliance
upside down and place it on a cushioned mat.
Take care that the ignition devices and flame
supervision devices are not damaged in this
operation.
• Attach the sponge provided around the edge of
the appliance.
• Do not leave a gap in the sealing agent or
overlap the thickness.
The thickness of the sponge material is 0.12" (3
mm). The width of the sponge material is 0.39" (10
mm). Attach the sponge around the edge of the
hole in the worktop.
Dimension/Clearance
CAUTION
• Do not use a silicone sealant to seal the
appliance against the aperture. This will make it
difficult to remove the appliance from the
aperture in future, particularly if it needs to be
serviced.
• Make sure to install the stabilizing brackets to
prevent tipping of the appliance.
1
Place the bracket
the size of the screws. There are one set of
screw holes in each corner of the cooktop.
Slightly tighten a screw
bracket
the cooktop. Adjust the position.
2
Carefully turn the cooktop back over and then
gently lower it into the hole that you have cut
out.
3
On the underneath of the cooktop, adjust the
brackets into a position that is suitable for
your worktop. Then fully tighten the screws to
secure the cooktop into position.
INSTALLATION
CBGD2414S
2
3 3/8" (85 mm)
24" (610 mm)
2
1
13" (330 mm)
2
30" (762 mm)
2
18" (457 mm)
over the holes that match
b
through the
c
so that the bracket is attached to
b
7
Advertisement
