Electrolux EWD746PCBI User Manual page 22

7.3 Mode
Thanks to this button, a cycle can perform:
• Only washing: Mode - Wash indicator is
on (default mode).
• Washing and drying: Mode - Wash and
Mode - Dry indicators are on.
• Only drying: Mode - Dry indicator is on.
7.4 Temperature
When you select a washing programme, the
appliance automatically proposes a default
temperature.
Tap on this button to change the water
temperature.
The indicator of the set temperature comes
on.
The indicator Cold corresponds to cold water.
7.5 Spin
When you set a programme, the appliance
automatically sets the default spin speed.
Touch repeatedly this button to:
• Change the spin speed. The display
shows only the spin speeds available for
the set programme.
• Set the No Spin option
Set this option to deactivate all spin
phases. The appliance performs the only
draining phase of the selected washing
programme. Set this option for very
delicate fabrics. The rinses phase uses
more water for some washing
programmes
• Activate the Rinse Hold
The final spin is not performed. The water
of the last rinse is not drained out to
prevent the fabrics from creasing. The
washing programme ends with water in
the drum.
The indicator
stays locked and the drum turns regularly
to reduce creasing. You must drain the
water to unlock the door.
If you touch the Start/Pause
the appliance performs the spinning phase
and drains the water.
22 ENGLISH
.
option.
is on display. The door
button,
The appliance empties the water out
automatically after 18 hours
approximately.
7.6 Prewash
With this option you can add a prewash
phase to a washing programme.
The corresponding indicator above the touch
button illuminates.
Use this option to add a pre-wash phase at
30 °C before the washing phase.
This option is recommended for heavily soiled
laundry, especially if containing sand, dust,
mud and other solid particles.
The option can increase the programme
duration.
7.7 Permanent Extra Rinse
With this option you can permanently have an
extra rinse when you set a new programme.
To activate/deactivate this option, hold the
Prewash button pressed for 3 seconds until
the indicator comes on/goes off on the
display.
When it is activated, the appliance will default
to this option after you switch it off or change/
reset the programme.
This option increases the programme
duration.
7.8 Time Manager
With this option you can reduce the
programme duration depending on the load
size and the degree of soiling.
When you set a washing programme, the
display shows the default duration and
dashes.
Touch Time Manager button to reduce the
programme duration according to your needs.
The display shows the new programme