Table of Contents
Advertisement
11.6 Starting a programme
Touch the Start/Pause
programme. It is not possible to start the
programme when the indicator of the button
is off and doesn't flash (e.g. the door is open).
The related indicator stops flashing and stays
on.
The programme starts, the door is locked.
The display shows the indicator
indicator appears to indicate that it is still
possible to stop the cycle and add garments.
The drain pump can operate shortly
before the appliance fills water.
11.7 Starting a programme with the
delay start
1. Touch the Delay Start button repeatedly
until the display shows the desired delay
time. The related indicator comes on.
2. Touch the Start/Pause
appliance door locks and starts the
countdown of the delay start. The display
shows the indicator
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after the
countdown has started
To cancel the delay start:
1. Touch the Start/Pause
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button repeatedly
until the display shows .
3. Touch the Start/Pause
start the programme immediately.
Changing the delay start after the
countdown has started
To change the delay start:
1. Touch the Start/Pause
pause the appliance. The related
indicator flashes.
34
ENGLISH
button to start the
and the
button. The
.
button to
button again to
button to
2. Touch the Delay Start button repeatedly
until the display shows the desired delay
time.
3. Touch the Start/Pause
start the new countdown.
11.8 The SensiCare System load
detection
The programme duration in the display is
referred to a medium/high load.
After touching the Start/Pause
SensiCare System starts the laundry load
detection:
1. The appliance detects the load in the first
30 seconds. During this phase the Time
Manager bars
time digits play a simple animation, the
drum rotates shortly.
2. The programme duration will be adjusted
accordingly and could increase or
decrease. After further 30 seconds, the
water filling starts.
At the end of the load detection, in case of
drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible to
pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pause
programme again. The SensiCare phase can
be repeated up to three times (see point 1).
Important! If the laundry amount will not be
reduced, the washing programme starts
anyway, despite the overload. In this case, it
will be not possible to guarantee the best
washing results.
About 20 minutes after the programme
start, the programme duration could be
adjusted again depending on the
capacity of water absorption of the
fabrics.
button again to
button, the
placed below the
is
button to start the
Advertisement
Table of Contents
