Pioneer F227 Operating Instructions Manual page 6

NAMES AND USES OF PARTS
@ {llustration shows model F-227L
@Q PIDNEER ewan oicitaL syvtHesizen tuner F-227L
Polen
STAN| BY/ON
QM
LD win sfra 0
@ POWER (STANDBY/ON) switch
ON uu... eee When set to ON position, power is supplied and the unit
becomes operational.
STANDBY... When set to STANDBY position, the main power flow is
cut and the unit is no longer fully operational. A minute
flow of power feeds the unit to maintain operation
readiness.
Disconnect the power cord from the power outlet when
; you do not plan to use the unit for a long period of time.
NOTE:
¢ The memory will be backed up so long as the power cord is not
unplugged.
© /f the power cord is unplugged, the memory will be retained for several
days.
@ STATION CALL switches
These are used to recall preset broadcasting stations and to preset the
station.
(3) MEMORY switch
This switch is used to memorize stations. When the switch is
pressed, the frequency indicator will flash. To memorize the
frequency of any station, press STATION CALL switch while the
frequency display is flashing.
@ BAND selector switches
These are used to select the band of the desired station.
(F-227L) AM reception
[_ MW reception-—~—————> LW suka
The bands change alternately each time the switch is pressed.
6
<ARE1157>
En
STATION CALL
wie me 195 2e 868 25~ 38
CE -=)
' Mate Unload oom Oe
[ oreras ff evzoraef orev9 [roe] = '|
a4 po Same — ry a emer? oy — oF Oyen yey a
©) TUNING switches
These are used to locate the stations.
Push the ''—'' switch to go a lower, and the ''+"' switch to go toa
higher frequency.
© STEREO indicator
This lights when a stereo program has been picked up during an FM
broadcast.
@ TUNED indicator
This lights to indicate when the finest tuning of a station has been
achieved.
FREQUENCY display
Permits reading the received frequency at a glance from the displayed
figure. The FM band is indicated by MHz, and the AM band by kHz.
() FM MODE (AUTO/MONO)
Normally this is set to the off position (the MONO indicator goes off).
When noise spoils the reception of an FM Program, press the switch
to the on position (the MONO indicator will now light). The program
of an FM stereo broadcast will be heard in mono. The setting of FM
MODE (AUTO/MONO) switch {on or off) is memorized along with the
station's frequency in STATION CALL switches.
When using the preset tuning feature, reception will be in the mode
selected when the station was memorized. This switch will not function
for AM reception.
@® TUNING MODE (AUTO/MANUAL)
Use to select either the AUTO mode or MANUAL mode for FM/AM
reception. (When the auto tuning mode is selected, the AUTO indicator
will now light.)
NOTE FOR F-227L:
Auto tuning is not possible on the LW band.