Table of Contents
Advertisement
Tabs
When the menu display area or a pop-up window
comprises several pages, each page is displayed on a tab.
Select a tab to change the display.
Selecting and Setting List Items
When the target of an operation is selectable from
multiple items, the items are displayed in a list.
Select All checkbox
Number selection button
List display
You can move the display position in a list using a swipe
operation or using the scrollbar slider in order to select a
target item.
The row for the item that has focus is shown in light blue.
When multiple items in a list can be selected, a checkbox
is displayed on the left side of each item.
Selecting using a checkbox
To select an item, place a check mark in the checkbox.
Slider
Operation
Scrollbar
buttons
To select multiple items, place a check mark for the target
items for operation.
Select All checkbox
To select or deselect all items, use the Select All
checkbox.
When there are items selected in a list, a blue square is
displayed in the Select All checkbox.
To select all items, place a check mark in the Select All
checkbox.
To deselect all items, clear the check mark from the Select
All checkbox.
Selecting by entering a list number
If a number selection button is displayed below the list,
you can enter a list number to select an item.
Press the number selection button to display the numeric
keypad window.
Enter the number of the target item and press [Enter].
When selecting multiple items, use a hyphen or comma to
specify numbers.
Example:
To select list items 1 to 5, enter "1-5".
To select list items 1, 3, and 5, enter "1,3,5".
Button operations in a list
When setting items in a list, operation buttons may be
displayed in the list depending on the menu.
In this manual, list item button operations use the
following convention.
Example:
Operating a button in the [Tally Assign] row for an item
in the list using the Home > Setup > Router/Tally > Tally
> Parallel Tally menu (19106.26).
1 Open the Home > Setup > Router/Tally > Tally >
Parallel Tally menu (19106.26).
2 Select the target parallel output port to set.
3 Press the [Tally Assign] button and select the type of
tally from the pull-down list.
When there is only one target item
Selection of the item is not required.
In step 2 of the procedure above, check that the target
item in the list is displayed on the menu screen. If the item
is not displayed, move the display position in the list.
In subsequent procedure steps, you can configure settings
by pressing buttons displayed in the row of the target
item.
When there are multiple target items
In step 2 of the procedure above, place check marks in
individual checkboxes or in the Select All checkbox to
select target items.
Changes to the setting of one of the check marked items
will apply the same change in setting to the other target
items.
76
Advertisement
Table of Contents
