Sealey SA399 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instruction protection
manual
1. SAFETY
Disconnect the gauge from the air supply before servicing or performing any maintenance.
9
Maintain the gauge in good condition (use an authorised service agent), and keep the gauge clean for best and safest
9
performance.
Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Locate gauge in a suitable work area, keep area clean and tidy and free from unrelated materials and ensure there is adequate lighting.
9
Keep children and unauthorised persons away from the work area.
9
DO NOT direct gauge outlet at yourself or at other persons or animals.
8
DO NOT carry by the hose, or yank the hose from the air supply.
8
DO NOT use the gauge for a task which it is not designed to perform.
8
DO NOT operate the gauge when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT operate gauge if parts are missing or the gauge is damaged, as this may cause failure and/or personal injury.
8
2. INTRODUCTION
Die cast body and dial type gauge with rubber protector. Features a glow in the dark measuring scale. Displayed in psi and bar. Fitted
with 500mm rubber hose and single clip-on connector.
3. SPECIFICATION
Model no ..................................................................... SA399
Max. air supply ............................................................ 170psi
Min. air supply ............................................................... 10psi
Range .........................................................0-7bar (0-100psi)
Inlet size ...................................................................1/4" BSP
4. OPERATION
4.1. The air supply must be clean and dry, use a suitable filter/water trap.
4.2. The supply pressure must be to specification (see above).
4.3. ATTACH ADAPTOR TO VALVE
4.3.1. Push down clip and place the connector onto the tyre valve.
4.3.2. The connector will now be locked in place.
4.4. TO INFLATE
4.4.1. Momentarily depress the operation lever fully, then release to
display tyre pressure.
4.5.
Fully depress lever for an appropriate period. Avoid over inflation,
release lever frequently to check the pressure.
TO DEFLATE
4.5.1. Depress deflate button (until air can be heard escaping) for an appropriate period. Fully depress lever momentarily then
release to display new pressure.
IMPORTANT - ALWAYS FULLY DEPRESS LEVER MOMENTARILY BEFORE READING TYRE PRESSURE.
5. MAINTENANCE
5.1. PERIODIC CHECKS AND MAINTENANCE
For long service and accuracy, the following actions should be carried out at the recommended intervals:
WEEKLY - CHECK OPERATION
The gauge should be checked weekly for correct operation. Look for smooth lever operation and fast, smooth gauge movements.
Check for leaks from tyre connector seals, and for chafing or wear of the flexible hoses. Any problems should be immediately rectified.
QUARTERLY - CHECK CALIBRATION
We recommend the accuracy of the gauge be checked against a calibrated 'master' gauge every 3 months, or at shorter intervals
depending on operator's own quality procedures.
© Jack Sealey Limited
TYRE INFLATOR WITH CLIP-ON CONNECTOR
SA399
MODEL NO:
Original Language Version
Inflate lever
Deflate button
Clip
SA399 | Issue:1 22/01/20