Table of Contents
Advertisement
+14 volts
6.
Horizontal Frequency Adjustment
(Field Procedure)
a.
Set up the camera with the Videocorder in the
usual way.
Turn on all equipment and allow a
few minutes for warmup.
b.
Put the Videocorder in the E-to-E mode with
the motor running.
c.
Turn the core of L101 clockwise until the
picture falls out of syne.
Then turn the core
counterclockwise until the picture again falls
out of sync.
Set the core midway between the
settings at which the picture falls out of syne.
3-8.
POWER BOARD ADJUSTMENT
The regulated supply in the camera is set for a +14
volt output.
Connect the positive probe of an accu-
Fig. 3-8.
WHERE
TO MEASURE
+14V.
Advertisement
Table of Contents
