Table of Contents
Advertisement
Turning the Plasma Screen on
You may control your plasma screen with remote
control only when the device is in stand-by mode.
Switch the mains switch on. The standby indicator
turns red.
•
Press a digit key or Program
Up/Program Down key or the
PR+/PR+ or MENU key on the front
panel of the television to turn the
7
television on. Stand-by indicator turns
to green. The picture is displayed on
the screen after a few seconds. To
PR-
switch the television to stand-by mode,
push the Stand-by button. Stand-by
PR+
indicator turns to red.
• The Plasma screen is always connected to the
mains supply in stand-by mode. To cut the
connection completely, you should switch the
mains switch off and disconnect the mains lead
from the mains socket.
• The screen has an electric adaptor and it may be
operated with a supply voltage of 230V AC and
50Hz.
Note 1: If there is no broadcast signal, your television
will switch to stand-by mode in five minutes.
Note 2: If your remote control has a fault or its
batteries have been used up, there are "MENU"
"SOURCE", "
PROG
buttons to operate the TV.
Batteries
To reveal the battery compartment, remove the back
cover and make sure that you have inserted the
batteries correctly.
The batteries suitable for this remote control are UM-
4, IEC R03 or AAA 1.5V.
Do not mix a used, old battery with a new battery or
do not use mixed battery types.
The performance of the remote control will deteriorate
from a distance farther than 8 metres or out of an
angle of 30 degrees.
", "
VOL
" front panel
Operation Modes
ATTENTION
Note that at the beginning of use, the operation mode
should be in full screen format setting especially in
the first 100-150 operation hour (see: Displaying of
the sub-menu, Picture Format). This prevents
differences of brightness on picture areas.
Also, to prevent permanent shadows on the displayed
picture, avoid displaying any still images in the first
operation hours (computer mode, teletext pages,
Photo CD images, etc.). If the plasma television is
to be used as computer monitor, it is recommended
that you use a screen saver.
Computer mode
For the best image, we recommend 848 x 480, 640
x 480 or 720 x 400 pixel resolution. 848x480 pixel
resolution corresponds to the screen matrix and offers
the best image. You can obtain the driver for this
resolution from the Internet pages of well-known
graphic card producers. Unlike the applications in
CRT monitors, for a vibration free presentation on
flat screens, it is not necessary to select high image
reconditioning. 60Hz of reconditioning is
recommended.
Video recorder mode
If your recorder offers Y/C (S-Video) format playback,
it is recommended to use Y/C (S-Video) inputs to
improve image quality. DVD player mode
For the best use, it is recommended to use RGB
operation mode connectable to SCART 1 input. In
case your player does not offer this operation mode,
please use the Y/C (S Video) signal mode.
Image adherence
The manufacturer would like to state that during
watching frozen pictures (e.g. computer playback)
for long durations, the image remains still visible in
full mask for a few minutes when a different source
is played afterwards. This is known as "image
adherence". Please note this is normal operation and
not a fault.
Video cable
To connect video signal, high quality 75 Ω coaxial
cable should be used. A low-quality signal cable
may cause distortions and shadows on the displayed
picture as well as exceeding the permissible EMC
level. For perfect and safe operation of the device,
mechanical interlocks for single plug and outlet
sockets are necessary.
-13-
Advertisement
Table of Contents
