Canon imagePROGRAF iPF755 User Manual page 586

Network Setting
Note
•
The subnet mask and default gateway are set to "0.0.0.0." Use RemoteUI to change the subnet mask
and default gateway to match your network settings.
For details on RemoteUI, see "Using RemoteUI". (→P.571)
Conguring TCP/IPv6 Network Settings
When printing in a TCP/IPv6 network, you must congure the TCP/IPv6 settings on the Control Panel.
Follow the steps below to congure the TCP/IPv6 network settings.
1.
On the Tab Selection screen of the Control Panel, press ◄ or ► to select the Settings/Adj.
tab ( ).
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
2.
Press the OK button.
The Set./Adj. Menu is displayed.
3.
Press ▲ or ▼ to select Interface Setup, and then press the OK button.
4.
Press ▲ or ▼ to select TCP/IP, and then press the OK button.
5.
Press ▲ or ▼ to select IPv6, and then press the OK button.
6.
Press ▲ or ▼ to select IPv6 Support, and then press the OK button.
7.
Press ▲ or ▼ to select On, and then press the OK button.
Important
•
Once you set IPv6 Support to On, the IPv6 StlessAddrs setting takes effect.
•
You can also congure IPv6 StlessAddrs and DHCPv6 from the printer Control Panel.
570 Network Setting