Canon RealIS SX80 Mark II User Manual page 7

6
Complete the dialog with necessary information and click the [OK] button.
Category
First address
Last address
Community name
Timeout
Password
(SNMP V3 only)
Enable encryption
(SNMP V3 only)
Note
- An error message will appear and settings will not be registered if a value
of an entry is invalid or insufficient. Correct it as required.
- Entries will be cancelled if [X] (Close) or [Cancel] button is clicked before
clicking the [OK] button.
- To change a discovery range, select an item from the discovery range list
and click the [Edit] button to reconfigure the settings.
- To delete an unnecessary discovery range, select an item from the
discovery range list and click [Delete].
Enter a first IP address in the range for discovery, in "XXX.
XXX.XXX.XXX" form.
Enter a last IP address in the range for discovery, in "XXX.XXX.
XXX.XXX" form.
Enter a community name within 15 alphanumeric characters
and symbols.
Enter a number of seconds to time out, from 1 to 9.
Enter a password within 8 to 15 one-byte alphanumeric
characters and symbols.
Place a checkmark if encrypted. Remove a checkmark if not.
CHAPTER 1 • Introduction
Description
7