Canon RealIS SX80 Mark II User Manual page 9

4
Complete the dialog with necessary information and click the [OK] button.
Category
IP address
Port number
Timeout
Note
- An error message will appear and settings will not be registered if a value
of an entry is invalid or insufficient. Correct it as required.
- Entries will be cancelled if [X] (Close) or [Cancel] button is clicked before
clicking the [OK] button.
- To change an IP address, select an item from the discovery range list and
click the [Edit] button to reconfigure the settings.
- To delete an unnecessary IP address, select an item from the discovery
range list and click [Delete].
- Projectors may doubly display when the IP address of a projector is
changed. In this case, delete the projector with an old IP address.
Enter an IP address of the projector, in "XXX.XXX.XXX.XXX" form.
Enter a port number to be used, in one-byte numbers. Default
value is set to "7142."
Enter a number of seconds to time out, from 1 to 9.
CHAPTER 1 • Introduction
Description
9