To Show The Sim Information In Detail - D-Link DES-3010F Command Line Interface Reference Manual

show sim
Parameters
Restrictions
Example usage:

To show the SIM information in detail:

DES-3026:4#show sim
Command: show sim
SIM Version
Firmware Version
Device Name
MAC Address
Capabilities
Platform
SIM State
Role State
Discovery Interval
Hold Time
DES-3026:4#
DES-30XX Layer 2 Switch CLI Reference Manual
always have the candidate role.
Discovery Interval - Time in seconds the Switch will send discovery
packets out over the network.
Hold time – Displays the time in seconds the Switch will hold
discovery results before dropping it or utilizing it.
candidates <candidate_id 1-100> - Entering this parameter will
display information concerning candidates of the SIM group. To
view a specific candidate, include that candidate's id number, listed
from 1 to 100.
members <member_id 1-32> - Entering this parameter will display
information concerning members of the SIM group. To view a
specific member, include that member's ID number, listed from 1 to
32.
group commander_mac <macaddr> - Entering this parameter will
display information concerning the SIM group of a commander
device, identified by its MAC address.
neighbor – Entering this parameter will display neighboring devices
of the Switch. A SIM neighbor is defined as a switch that is
physically connected to the Switch but is not part of the SIM group.
This screen will produce the following results:
Port – Displays the physical port number of the commander
•
switch where the uplink to the neighbor switch is located.
MAC Address – Displays the MAC Address of the neighbor
•
switch.
Role – Displays the role (CS, CaS, MS) of the neighbor
•
switch.
Only administrator-level users can issue this command.
: VER-1.50
: Build 2.00.020
:
: 00-35-26-11-11-00
: L3
: DES-3026 L2 Switch
: Enabled
: Commander
: 30 sec
: 100 sec
158