Setting For Barcode Reader - Panasonic Toughbook CF-U1GQG6L2M Reference Manual

Barcode Reader

Setting for Barcode Reader

Click on the notification area then the following menu opens by clicking
model with 2D Barcode Reader) icon.
Connection to Barcode
(Power Saving Mode)
Connection to Barcode
(Always-On)
Disconnect Barcode Module
Confirmation Message On
*2
Add Enter-Key code
Exit 1D Barcode Key Emulator
About 1D Barcode Key Emulator
*3
Allow Code 39
*3
Packet Mode
Exit 2D Barcode Key Emulator
About 2D Barcode Key Emulator
*1
The confirm message is closed in the following cases.
• When five seconds pass from the display message.
• When the [Close] in the message window is clicked.
• When the trigger button is pushed again.
*2
This list appears only for model with 1D Barcode Reader.
*3
This list appears only for model with 2D Barcode Reader.
To reduce the power consumption, stop barcode reader connection within 1 minute
after reading a barcode.
Keep barcode reader active even after reading a barcode.
Stop barcode reader connection in Always-On mode or Power Saving Mode.
If the trigger button is pressed in Power Saving Mode, "Push Barcode Trigger
again to enable Barcode." message is displayed to prevent operational errors.
Add a line feed code after a barcode string.
*2 Exit barcode reader operation.
*2 Display version Information of 1D Barcode Key Emulator.
Allow Code 39 type barcode. You can change the setting by scanning Enable/Dis-
able of Code39.
Receive barcode decode data in packet mode.
Exit barcode reader operation.
*3
Display version Information of 2D Barcode Key Emulator.
*3
(for model with 1D Barcode Reader) /
58
(for
*1