Pioneer PDP-5010FD Operating Instructions Manual page 22

Preparation
05
When using the hung on wall unit (PDP-6010FD)
Note
• First lay the plasma display on top of a soft sheet etc., remove
the stand, then attach the speaker mounting fittings.
• Install the plasma display on the wall with only the speaker
mounting fittings and speaker cable attached to the display,
and then attach the speaker. (See page 19)
• To facilitate attachment of wiring, it is recommended to
complete the wiring on the sides of the plasma display before
mounting speaker to the display.
Caution
• Be careful about the speaker mounting fittings when installing
or connecting. This may result in injury.
1 Connect the supplied speaker cables to the back of
the plasma display.
2 Place the plasma display on the mounting fittings
of the hung on wall unit.
For details, refer to the instruction manual supplied with the
hung on wall unit.
4
Speaker mounting
screw (M5 x 10 mm)
22
En
2
When using the hung on wall
unit, do not use these holes.
3 Connect the other end of the speaker cables to the
speaker.
4 Place the speaker on the speaker mounting
fittings in the correct direction.
5 Tighten using the supplied screws (four locations).
• Tighten the four screws in order
the drawing.
The screw hole at the rear surface of the speaker mounting
fitting is used when the plasma display is installed with the
table top stand. It is not used when installed on the wall.
Note
• If after attaching the speaker its position needs to be adjusted
horizontally, first loosen the speaker mounting screws,
reposition and then tighten the screws again at the appropriate
position.
6 Bundle the cables.
• Bead bands are included with the plasma display.
• Use the bead bands as necessary.
• When tidying up your speaker cables, make sure to bundle
them so that they are not subjected to any pressure.
Speaker mounting screw
(M5 x 10 mm)
1
Speaker mounting screw
(M5 x 10 mm)
, , , as shown in
3