Dell W3202MH Owner's Manual page 37

Problem
No audio
PIP/PBP/POP not working
No video
Possible Solution
Ensure the green audio cable is connected to audio connectors
1
on the TV and on the computer. For the location of the
connector on the TV, see "Using the VGA Connector" on
page 16. See your computer documentation for the location of
connectors on your computer.
Ensure the volume on the computer is not muted.
2
Verify that sound on your computer is working by checking the
3
speakers. See your computer documentation for information on
troubleshooting your computer.
Disconnect the TV from the computer and test to see if the TV
4
volume works.
Ensure the settings in the TV Menu are properly set. Press
1
Menu button to enter the TV Menu, and select PIP/PBP/POP .
Swap the video and audio source.
2
NOTE:
If you see a self-test, it means there is a problem with
your video card or you are using the wrong input source.
Ensure the TV is turned on.
1
Verify that all the cables are properly connected to the TV,
2
including the power cable.
Check to see if there is a blue or amber light on the lower,
3
right-hand corner of the TV. A blue light indicates the TV is on.
An amber light, means the TV is in power save mode.
Ensure VGA is selected in the Input Select menu. See "Input
4
Select" on page 24 for more information.
Reconnect the computer.
5
Connect another device that you know is working properly.
6
Reset the original factory defaults. Press Menu button, select
7
Setup, and then select Factory Reset.
Troubleshooting Your TV
37