Other Notes - NEC MOBILE TERMINAL EX User Manual

Handling the Power Switch
The power switch is used to turn on or off the power. A push-type switch is located at the
position shown in the figure below.
The power switch returns to the original position if you press the power switch and then
release it.
Pressing the power switch once causes the power to be turned off (suspend) if the power is
ON or to be turned on if the power is OFF (resume).
The power is forcibly turned off if you press the power switch continuously for 25 seconds
or longer.
(The power of Mobile Terminal EX is turned off. In the next start, the system boots from
Windows.)
CAUTION
CAUTION
CAUTION
Handling the Reset Switch
The reset switch is used to restart the device.
The reset switch may be pressed according to the direction of the system administrator.
The reset switch returns to the original position if you press the reset switch and then
release it. (Use a bar with round tip to press the reset switch preferably.)

Other Notes

If you press two points on the touch panel at a time, the center of the two points is entered.
Do not type keys on the keyboard repeatedly without reason in the period
between the depression of the power switch and OS starting. Repeated key
depressions may sometimes cause OS to be started unsuccessfully. If OS is
started unsuccessfully, press the reset switch to restart the OS.
It takes some time to exit from applications correctly and turn off the power
actually (suspend) after the power switch is pressed in the power-on status.
While the power lamp on the rear side of Mobile Terminal EX is lit, some
processing is done even if the screen display disappears. Do not remove the
BATTERY PACK until the power lamp goes off. Failure to follow it may cause
some data to be broken.
Do not remove the BATTERY PACK if the power is ON.
-
Power switch
Reset switch
17 -