NEC C Manual page 48

FEDERAL COMMUNICATIONS COMMISSION
RADIO FREQUENCY INTERFERENCE STATEMENT
WARNING: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy, and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures.
T
Reorient or relocate the receiving antenna.
T
Increase the separation between the equipment and receiver.
T
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
T
Consult the dealer or an experienced radio/TV technician for help.
Use shielded and properly grounded I/O cables and power cable to ensure
compliance of this unit to the specified limits of the rules.
If necessary, the user should contact the dealer or an experienced radio/television
technician for additional suggestions. The user may find the following booklet,
prepared by the Federal Communications Commission, helpful: "How to Identify and
Resolve Radio-TV Interference Problems." This booklet is available from the U.S.
Government Printing Office, Washington, D.C., 20402, Stock No. 004-000-00345-4.
(For United States Use Only)