The Functions Of The Control Panel - NEC NW-452 Instruction Manual

THE FUNCTIONS OF THE CONTROL PANEL

• Press this switch to turn the power on or off.
• Used to choose water temperature being supplied.
• As the button is pressed, water temperature will toggle between.
COLD
• In the case of a single valve model, there is no wash temperature
selector function.
• Used to adjust the amount of water according to the size of the
load to be washed.
• As the button is pressed the water level is selected as follows:
MID
• Used to pre-engage time for wash.
DELAY
• Used for the partial process or the combination of each
CYCLE
cycle (wash, rinse, spin) (See page 10)
• If you want to change wash times, rinse times or spin times, you must
press this button after selecting each cycle by the cycle button.
CONTROL
Also, this button can be used to spin only. (See page 10)
• Used to select the full-automatic program.
• As the button is pressed the program will be selected in the following order:
PROGRAM
FUZZY+SOAK HEAVY
• Operation and temporary stop is repeated as it is pressed.
• When you want to change a course during operation;
press the "START/HOLD" button
change
HOURS
DELAY
CONTROL
COLD+HOT HOT
HIGH LOW
HEAVY+SOAK
press the "START/HOLD" button again.
8
DELICATE
PROGRAM
CYCLE
SPEEDY DELICATE
select the program that you want to
FUZZY