Table of Contents
Advertisement
Additionally, there are important facts you should know about the VLAN FDB:
•
•
•
•
•
•
NOTE
For more information on frame handling for Dell FCoE hardware, see
page 3.
VLAN configuration guidelines and restrictions
Follow these VLAN configuration guidelines and restrictions when configuring VLANs:
•
•
•
•
Default VLAN configuration
Table 7
TABLE 7
Parameter
Default VLAN
Interface VLAN assignment
VLAN state
MTU size
Port assignment
Dell Converged Enhanced Ethernet Administrator's Guide
53-1002116-01
The VLAN FDB contains information that helps determine the forwarding of an arriving frame
based on MAC address and VLAN ID data. The FDB contains both statically configured data
and dynamic data that is learned by the switch.
The dynamic updating of FDB entries using learning is supported (if the port state permits).
Dynamic FDB entries are not created for multicast group addresses.
Dynamic FDB entries are aged out based on the aging time configured per Dell FCoE hardware.
The aging time is between 10 and 1000000 seconds. The default is 300 seconds.
You can add static MAC address entries specifying a VLAN ID. Static entries are not aged out.
A static FDB entry overwrites an existing dynamically learned FDB entry and disables learning
of the entry going forward.
Make sure your converged mode interface is not configured to classify untagged packets to the
same VLAN as the incoming VLAN-tagged packets. By configuring a converged interface to
classify untagged packets (by using classifiers or the default port VLAN ID) to the same VLAN
as VLAN-tagged packets coming into the interface, the FCoE hardware sends out untagged
packets to the CNA. These packets may be dropped, disrupting communications.
In an active topology, MAC addresses can be learned, per VLAN, using Independent VLAN
Learning (IVL) only.
A MAC address ACL always overrides a static MAC address entry. In this case, the MAC address
is the forwarding address and the forwarding entry can be overwritten by the ACL.
The Dell CEE switch supports Ethernet DIX frames and 802.2 LLC SNAP encapsulated frames
only.
lists the default VLAN configuration.
Default VLAN configuration
VLAN configuration guidelines and restrictions
Default setting
VLAN 1
All interfaces assigned to VLAN 1
Active
2500 bytes
VLAN 4095
"Layer 2 Ethernet overview"
33
5
on
Advertisement
Table of Contents
