To enable spanning tree on the CEE interface, perform the following steps from Privileged EXEC
mode.
1. Enter the configure terminal command to access global configuration mode.
2. Enter the interface command to specify the CEE interface type and slot/port number.
3. Enter the no shutdown command to enable the CEE interface.
4. Enter the spanning-tree command to enable spanning tree on the CEE interface.
Disabling spanning tree
From the CEE interface, use this command to disable spanning tree on the CEE interface. By
default, spanning tree is disabled.
To enable spanning tree on the CEE interface, perform the following steps from Privileged EXEC
mode.
1. Enter the configure terminal command to access global configuration mode.
2. Enter the interface command to specify the CEE interface type and slot/port number.
3. Enter the no shutdown command to enable the CEE interface.
4. Enter the spanning-tree command to enable spanning tree on the CEE interface.
Dell Converged Enhanced Ethernet Administrator's Guide
53-1002116-01
switch(config)#interface intengigabitethernet 0/1
switch(conf-if-te-0/1)#no spanning-tree shutdown
switch(config)#interface intengigabitethernet 0/1
switch(conf-if-te-0/1)#spanning-tree shutdown
Configuring STP, RSTP, or MSTP on CEE interface ports
6
63