Dell Inspiron 600m Owner's Manual page 82

NOTICE:
tabs that secure the memory module.
6 If you are replacing a memory module, remove the existing module.
NOTICE:
Use your fingertips to carefully spread apart the securing clips on each end of the memory
a
module connector until the module pops up.
Remove the module from the connector.
b
NOTICE:
connector labeled "SLOT 1" before you install a module in the other connector.
7 Ground yourself and install the new memory module:
NOTE:
If the memory module is not installed properly, the computer does not boot. No error message
indicates this failure.
Align the notch in the module with the slot in the center of the connector.
a
NOTICE:
Holding the shorter, notched ends of the module, slide the edge of the module firmly into
b
the connector, and rotate the module down until you feel a click. If you do not feel the
click, remove the module and reinstall it.
8 Replace the cover and screw.
NOTICE:
cover to close may damage your computer.
82
Adding and Replacing Parts
To prevent damage to the memory module connector, do not use tools to spread the inner metal
Handle memory modules by their edges, and do not touch the components on a module.
If you need to install memory modules in two connectors, install a memory module in the
Only hold the module by the shorter, notched ends. Do not push on the longer, outer edge.
If the memory module cover is difficult to close, remove the module and reinstall it. Forcing the