Advertisement
4.
Pressing the "Next" key will store the values of WSWl in the EEPROM
and make "WSW2" available for change. When the unit is set to the
factory default settings, the LCD will display
3 lists the function of 8aCh
5.
In this mode, every time the "NEW key is pressed, the Current switch
settings are finalized and the next switch bank, WSWl, WSW2 or
WSW3, in that order, is made available. Table 4 lists the function of
each WSW3 switch.
6.
If the "SF key is pressed, the current switch bank settings are saved.
The unit then emits one long beep indicating that it has returned to the
initial maintenance mode.
"STOP"
7.
initial
maintenance mode.
SECOND LEVEL SOFT SWITCH FUNCTION DESCRIPTIONS
signal that suppresses echoes, instead of a 2100
echo suppressor (ES). Suppressing th8 8Cho8S provides a more
Table 2 Switches 2 & 3: Overseas communication mod8 (Transmission)
DIS signal sent from the calling station for suppressing echoes. Note:
Some called models may cause an error by receiving an echoed DIS.
Hz signal for 3 Seconds upon detection of the
enables a
Table 2 Switch 4: Direct connection mod8
When this 8witoh is set to 1, the unit starts receiving
the hand set is on - hook or off - hook. This mode is used for Cross
testing 2 fax machines when they are connected directly to 8aCh other.
WSW2
key is preSSed, any changes made are canceled.
no-
PSB No: P-0070
Page: 4 of 8
switch.
Hz which
DIS V.21 flag. This
a
disables the
signals from the
Advertisement
