Yamaha Tyros2 Owner's Manual page 186

Reference
Mixing Console
● Line Out settings for each part or channel
Set the output configuration for the
selected part by checkmarking or
un-checkmarking the appropriate
column (jack).
Select the desired part.
■ MAIN jacks
The part, channel or percussion sound of which the MAIN box is checkmarked will be
output from the following jacks. This output sound includes the effect settings.
• MAIN jacks on the rear panel
• PHONES jack
• LOOP SEND jack
• Optional Speaker
■ SUB jacks
The part, channel, or percussion sound of which the SUB1, SUB2, or SUB1&2 box is
checkmarked will be output from the jacks as described below.
• When any of the SUB1/SUB2/SUB1&2 boxs are checkmarked, the part (channel)
or percussion sound will be output via the corresponding jacks. In this case, only
Insertion effects can be applied; System effects and other effects will not be applied
to the output sound.
• When any of the SUB1/SUB2/SUB1&2 boxs are checkmarked, the part (channel)
or percussion sound will not be output through the MAIN/PHONES/LOOP SEND
jack or optional connected speakers.
• When the SUB1&2 box is checkmarked, the part (channel) or percussion sound will
be output in stereo (1: left, 2: right).
• When the SUB1/SUB2 box is checkmarked, the part (channel) or percussion sound
will be output in mono, respectively.
186
Tyros2 Owner's Manual
● Line Out settings for each instrument (key)
Set the output configuration for the selected drum sound
by checkmarking or un-checkmarking the appropriate col-
umn (jack).
• When checkmarking the box of "DEPEND ON PART":
The selected drum sound will be output via the jacks
set from the PANEL page at left.
• When checkmarking the box of one of a column
other than "DEPEND ON PART":
An individual percussion setting overrides the Part set-
tings made from the PANEL page at left.
Select the desired drum instrument.
NOTE
• When using one of the SUB Line
Out settings, make sure that
you've connected cables to the
appropriate LINE OUT SUB jacks
on the rear panel. If cables are
only connected to the MAIN jacks,
the sound of the Part will be out-
put through the MAIN jacks, even
if one of the SUB1/SUB2/SUB1&2
is checkmarked.