External Drives; Power Requirements; What Are The Mounting Requirements For An Internal Tape Drive; Mounting Bay - HP 157770-001 - DAT Drive 20/40 Tape User Manual

Figure 4 USB cables
.
• A USB cable with a 4–pin Intel connector (blue)
• A USB cable with a 4–pin ProLiant connector (red)
• A standard USB cable
NOTE:
If your server does not have an internal USB port, you must purchase and install a separate USB HBA
with an internal port before you install the tape drive. See
recommended products.

External drives

A power cable is provided with your HP StorageWorks DAT tape drive.
The USB 2.0 cable is pre-fitted to the tape drive, you cannot remove it.

Power requirements

Power requirements are:
Table 2 Power requirements
Voltage
DAT 320
5 V
12 V

What are the mounting requirements for an internal tape drive?

Mounting bay

You need one industry-standard, 5¼-inch, half-height bay in which to install the HP StorageWorks
DAT tape drive.
16 Before you start
Typical Current
DAT 160
0.70 A 1.54 A
0.25 A 0.26 A
http://www.hp.com/go/connect
DAT 72/40/
DAT 320
24
0.7 A 1.4 A
0.3 A 1.3 A
for
Maximum Current
DAT 72/40/
DAT 160
24
1.61 A 0.8 A
1.3 A 1.0 A