Verify Installation - HP 157770-001 - DAT Drive 20/40 Tape User Manual

5 Verify installation

Once you have installed the drive hardware, check that drivers have been installed correctly and you
have the correct version of backup software, and verify that the tape drive is functioning properly
before you store your valuable data.
NOTE:
Certain backup applications require you to use their own Tape driver instead of the HP Tape driver.
1. Switch on the drive and the server.
2.
The tape drive will run its hardware self-test, which takes about 5 seconds.
HP StorageWorks DAT 320 and DAT 160 drives: During self-test all the LEDs turn on and turn off
again at completion. If self-test passes and there is a cartridge in the drive, the green Ready LED
then shows steady green. (If there is no cartridge, the Ready LED is off.) If the test fails, the Drive
Error and Tape Error LEDs flash, while the Ready and Clean LEDs are off. This continues until the
drive is reset.
All other drives: If self-test passes, both front panel lights should be off. If a hard error causes the
self-test to fail, the clean light changes to steady amber.
See "Operating your tape
• If you installed drivers before connecting the tape drive (Windows only)
The tape drive should be detected automatically and the correct drivers used. (See
"Install drivers
and check that both drivers have been installed, as described in
"Verifying USB installation for optimum
• Installing drivers after connecting the tape drive (Windows only)
If you have not already installed drivers, the Windows Found New Hardware wizard will
run when you power on the server and tape drive. Cancel it and install the drivers as described
in "Alternative install process, after connecting the tape
• Installing drivers (other operating systems)
Drivers are included with the operating system and should be loaded automatically. See also
"Check drivers
3.
Verify that the tape drive installation was successful.
For many operating systems you can run HP Library & Tape Tools from the HP StorageWorks
CD-ROM. See also
HP Library & Tape Tools, HP's free diagnostics and troubleshooting software.
If you encounter a problem during this verification procedure, turn to "Troubleshooting" on page
61 for help in diagnosing and fixing the problem.
drive" on page 37 for more information about front panel lights.
" on page 19.) If the Windows Found New Hardware wizard runs, cancel it
(Linux)" on page 64.
"Diagnostic Tools and
performance" on page 63.
drive" on page 20.
Performance" on page 57 for more information about
DAT USB Tape Drives 35