Attaching and Removing the Dust
Cover
Attaching the Dust Cover
1
Align the dust cover's hinge clips (one on each side) with the
pins of the drive bezel.
•
The dust cover should be positioned so that the magnets
cover's back face the drive bezel.
*
This magnet does not affect the tape of the cartridge.
•
Holding the dust cover at an angle, as shown in the figure below,
set the hinge clips on top of the bezel pins, positioning them so that
they bracket the pins.
2
Press down at an angle on each side in turn until you hear
the hinge clips click into place.
*
on the
17