Parts Supplied; Installation Using The Screw Holes On The Side Of The Navigation Unit - Pioneer AVIC Z3 - Navigation System With DVD player Installation Manual

Section
03 Installation

Parts supplied

The navigation unit
Flush surface screw
(5 mm × 6 mm)
(8 pcs.)
Installation using the screw
holes on the side of the
navigation unit
% Fastening the navigation unit to the
factory radio-mounting bracket.
Position the navigation unit so that the brack-
ets screw holes and its screw holes are
aligned (are fitted), and tighten the screws at 3
or 4 locations on each side.
Use either the binding screws (5 mm × 6 mm)
or flush surface screws (5 mm × 6 mm), de-
pending on the shape of the bracket's screw
holes.
24
En
Binding screw
(5 mm × 6 mm)
(8 pcs.)
Frame
Factory radio mounting bracket
Binding screw or
flush surface screw
Be sure to use the
screws supplied
with this navigation
system.
Note
In some types of automobiles, discrepancy may
occur between the navigation unit and the dash-
board. If this happens, use the supplied frame to
fill the gap.
If the pawl gets in the
way, bend it down
Dashboard or console