Notice For The Blue/White Lead; Parts Supplied - Pioneer AVIC Z3 - Navigation System With DVD player Installation Manual

Section
02 Connecting the System
! If [Auto ANT] mode is set to [Power], the
vehicle's antenna can be stowed or turned
off only when the ignition switch is turned
off (ACC OFF).
! Do not connect this lead to the system con-
trol terminal of external power amps.
! Be sure not to use this lead as the power
supply lead for the auto-antenna or anten-
na booster. Such connection could cause
excessive current drain and malfunction.

Notice for the blue/white lead

! When the ignition switch is turned on (ACC
ON), a control signal is output through the
blue/white lead. Connect to an external
power amp's system remote control term-
inal (max. 300 mA 12 V DC). The control sig-
nal is output through the blue/white lead,
even if the audio source is switched off.
! Do not connect this lead to the auto-anten-
na relay control terminal or the antenna
booster power control terminal.
! Be sure not to use this lead as the power
supply lead for the external power amps.
Such connection could cause excessive
current drain and malfunction.
6
En

Parts supplied

The navigation unit
Connector
Extension lead
(for speed signal)
RCA connector 1
(CONNECTOR 1)
<See page 10, 12, 16,
19>
Microphone
Power cord
<See Page 12, 14, 18>
Extension lead
(for reverse signal)
GPS antenna
RCA connector 2
(CONNECTOR 2)
<See Page 8, 10, 18, 20>