Modifying The Configuration; Fiery Webtools - Epson C850071 - RIP Station 5000 User Manual

Modifying the configuration
You should edit the configuration whenever there is any change that would affect your
original configuration, such as a change in IP address. First change the specific RIP Station
Setup information before configuring the connection.
T
O MODIFY THE CONFIGURATION
1. To edit information for a RIP Station in the list of available servers, select the RIP Station
by its nickname and click Modify. Edit information in the Modify Server Settings dialog box
as necessary, and click OK when finished.
2. To add a new RIP Station to the list of available servers, click Add. Configure the Add New
Server dialog box as outlined in step 3 through step 5 above.
3. To remove a RIP Station from the list of available servers, select the RIP Station by its
nickname and click Remove.

Fiery WebTools

In order for network users to access and use Fiery WebTools, you need to set certain
RIP Station options in Setup. The names of these options have changed since version 1.1.
T F
O VERIFY THAT IERY
1. Print the Configuration page from the RIP Station Control Panel.
For Instructions see the User Guide.
2. On the Configuration page, check the following:
• In NetworkSetup>Port Setup>Ethernet Setup, confirm that "Enable Ethernet" is set to
Yes.
• In Network Setup>Protocol Setup>TCP/IP Setup, confirm that TCP/IP is enabled and
that there is a valid, unique IP Address for the RIP Station.
• In Network Setup>Service Setup, confirm that Web Services are enabled.
3. If all the conditions listed in step 2 are currently set, the RIP Station is properly set up to
use Fiery WebTools.
If any of the conditions listed in step 2 are not currently set, you must change them (as
described in the Administrator Guide) before you can use Fiery WebTools.
:
W T
EB OOLS ARE SET UP ON THE
RIP S :
TATION
Page 18