Epson C850071 - RIP Station 5000 User Manual page 51

Port Setup (Token Ring)
A Token Ring option is not available for the RIP Station. Therefore, these Setup options
cannot be selected.
T P S
O CONFIGURE ROTOCOL
• Click the Protocol Setup tab in the Network Setup window.
The RIP Station can accept jobs via TCP/IP (over Ethernet only), AppleTalk, and IPX/SPX
simultaneously. To configure the RIP Station, choose each protocol and enter the settings
for that protocol.
Protocol Setup (TCP/IP)
Enable on Ethernet
RIP Station over Ethernet cabling.
You must enable TCP/IP for Ethernet to use Fiery WebTools over Ethernet. If you are
using TCP/IP for printing from Windows NT 4.0 workstations, enabling TCP/IP here also
enables you to use Fiery utilities from Windows NT 4.0 workstations using TCP/IP proto-
cols.
IP Address (Ethernet)
the default 127.0.0.1 to a valid address for your network. For information about setting up
printing with TCP/IP, see Chapter 3 in the Administrator Guide.
Subnet Mask (Ethernet)
values:
• 255.0.0.0 if the IP address starts with a number less than 128
• 255.255.0.0 if the IP address starts with a number from 128 through 191
• 255.255.255.0 if the IP address starts with a number greater than 191
Be sure to confirm the subnet mask setting with your network administrator before
N :
OTE
proceeding. In some cases, the required setting may be different from those listed.
:
ETUP
—Click to enable if you have a TCP/IP network connected to the
—Enter the RIP Station IP address for Ethernet. You must change
—If you need to set the subnet mask, enter one of the following
Page 51