Faq; Q1. The Printer Does Not Operate Correctly; Q2. The Self Test Does Not Operate Correctly; Q3. Starting Up The Printer Takes A Long Time - Epson C32C824151 - UB E02 Print Server Technical Reference Manual

2.8 FAQ

2.8.1 Q1. The printer does not operate correctly. ("Serial interface" is printed by
the self test for the printer.)
2.8.1.1 A1. For TM-T90, TM-L90, TM-J2000, TM-J2100, TM-J7000, TM-J7100, TM-J7500, and
TM-J7600, set the #25 pin reset signal of the Memory switch set to disabled. For other
models, use the printer with the #31 pin reset signal of the DIP switch for parallel interface
enabled.
Model
TM-U200 Series
TM-U210 Series
TM-U230 Series
TM-U325 Series
TM-U590 Series
TM-U675 Series
TM-T88/T88II/T88III
TM-T90
TM-H5000/H5000II
TM-H6000/H6000II
TM-J7000/J7100
TM-J7500/J7600
TM-J2000/J2100
TM-L90

2.8.2 Q2. The self test does not operate correctly.

2.8.2.1 A2. Turn on the printer power while pressing the FEED button and hold the Feed
button until printing starts to perform the self test for the printer with the UB-E02. Printing
starts in approximately 6 seconds when the IP address is fixed or approximately 13
seconds when the IP address is acquired by auto setting. (It can be longer, depending
on the reply time of the host.)

2.8.3 Q3. Starting up the printer takes a long time.

2.8.3.1 A3. When the auto setting is set for IP address acquisition without a DHCP server,
starting up the printer takes about one minute. During this time, the self test for the printer
is not performed. Set the manual setting for IP address acquisition where the DHCP server
is not available.
Rev. A
Setting
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
MSW 1-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
MSW 1-8: ON
MSW 1-8: ON
MSW 1-8: ON
MSW 1-8: ON
UB-E02 Technical Reference Guide
Installation 2-7