To Set Up The Projector For Wired Network Access - HP Mp3130 - Digital Projector XGA DLP User Manual

To set up the projector for wired network access

You can connect the projector to a network. This action enables you and other
presenters to connect to the projector over the network.
1. Plug a CAT5 or equivalent network cable into the LAN port on the back of
the module. Connect the other end to the local network.
2. Turn on the projector. The left indicator light on the network port turns on
showing a 10- or 100-Mb/s connection. The light on the right shows network
activity.
The projector normally attempts to get an IP address from a Dynamic Host
Configuration Protocol (DHCP) server.
3. If you want to view or change the projector's TCP/IP network configuration,
open the on-screen menu and select Setup > Network. If the network is not
using a DHCP server, talk to your network administrator to find the correct
TCP/IP network settings.
Complete network information is shown in the on-screen menu under Help >
About the network.
4. On a networked computer, open Internet Explorer or Netscape Navigator, enter
the IP address of the projector into the URL bar, and press the Enter key.
5. In the browser, go to Networking > Wireless Presenter. Enter a projector name
to identify the projector for network presenters. You can also enter a projector
password that presenters must provide when they connect.
User's Guide
Setting Up the Projector
13