Advertisement
at the time of start
03H : The block number of transferred data is not consecutive.
USB connection
----------------------------------------------------------------------
This conforms to the USB1.1 standard.
Transfer speed: All speeds (supported)
Endpoint: Control transfer Endpoint 0
Device class: HID class (Ver1.1)
USB1.1 Standard: Universal Serial Bus Specification Revision 1.1
HID : Human Interface Device
Connector Specifications
1 VBUS (Power supply)
2 D-
(- Signal)
3 D+
(+ Signal)
4 GND (Ground)
* Depending on the USB host controller in the personal computer, the USB connection may fail to operate. When
using a USB hub, please use a self-powered type, not a bus-powered type. When using a USB hub, connection to
the first stage of the USB hub is recommended.
LAN connection
----------------------------------------------------------------------
[ Wired LAN port ]
LAN interface
Communication speed: Auto setting (10/100Mbps)
Certified standard: IEEE802.3 (10BASE-T)
IEEE802.3u (100BASE-TX, Auto-Negotiation)
A LAN connector (8 male RJ-45 connector)
1 TD+
Transmit data (+)
2 TD-
Transmit data (-)
3 RD+
Receive data (+)
4
Not used
5
Not used
6 RD-
Receive data (-)
7
Not used
8
Not used
[ Wired/wireless LAN card ]
The LAN connections will differ depending on the commercial LAN card that is used.
- For information on supported LAN cards, visit:
Global: http://www.nec-pj.com/
[Port Number]
The TCP port number used is "7142".
====================================================================
4. List of Commands
Advertisement
