Security Menu; Security Password; Security Password Change; Display Setting - Panasonic PT-D5000ELS Functional Instructions

SECURITY menu

Remote control
See "Navigating through the menu" on page 15.
See "Main menu and Sub-menu" on page 12.
Entering the SECURITY menu
Every time when you apply to the SECURITY menu, you
will be asked to perform the password operation. When
you apply to the SECURITY menu before you change
the password to your original, perform to input the
following factory default password operation.
Press F H G I F H G I and the ENTER button.
After you change the password
When you apply to the SECURITY menu after you
change the password to your original in the SECURITY
PASSWORD CHANGE menu, input the original
password operation.

SECURITY PASSWORD

You can activate the security system and the password
operation will be asked to perform when the projecting mode
started. Unless you perform the correct password operation, all
of the button controls will be disabled except the POWER
STANDBY and SHUTTER buttons.
OFF Deactive
ON Active
NOTE:
• When you activated the security system, make sure to change
the password to your original for safety.
• The factory default password is valid until you change the
password in SECURITY PASSWORD CHANGE menu.
SECURITY PASSWORD
CHANGE
You can change the password operation to your original.
1. Press a series of button operation up to 8 as a password
by using F G I and H.
2. Press the ENTER button.
3. Press the exact same series of button operation you
entered in the NEW password box for confirmation.
If a series of button operation is incorrect, you will be asked
to perform again.
4. Press the ENTER button.
NOTE:
• The entered password operations will appear as asterisks in
the box.

DISPLAY SETTING

You can set your original text, such as company name or URL
information, to display regularly on the projected image while
projecting.
OFF Deactive
Displays user defined text in TEXT
TEXT CHANGE on the screen while
projecting.
Displays user defined image over the
LOGO1
image.
Displays PANASONIC logo over the
LOGO2
image.

TEXT CHANGE

You can enter your original text up to 22 characters for
DISPLAY SETTING.
1. Enter your original text.
Use F G I H to specify the location of the required
character.
2. Press the ENTER button.
The selected character will be displayed in the text box.
3. Repeat until finish your original text.
Select < or > and press the ENTER button to move the
cursor in the text box.
Select BS and press the ENTER button to erase a
character.
4. Select OK and press the ENTER button.
Select CANCEL or press the MENU button to return to the
previous step.
NOTE:
• Special software is required to define the LOGO1 image.
Contact to an Authorised Service Centre.
E
NGLISH - 35